ASHLY KLR 2000 Power Amplifier

ASHLY

$599.00

Please direct any questions about the products we carry to sales@sodaaudio.com. We are happy to help.

KLR-2000
The two-channel power amplifier shall incorporate the latest amplifier technology to deliver a minimum power of 1,000 Watts per
channel into 2 Ohm loads, 600 Watts RMS per channel into 4 Ohm loads, or 350 WattsRMS per channel into 8 Ohm loads with both channels operating. The amplifier shall have rear panel switching for parallel mono and bridging modes. When switched into bridged-mono mode, the amplifier it shall deliver 2,000 Watts into a 4 Ohm load. The amplifier protection shall include output over-current, DC output, chassis temperature, and a mains circuit-breaker. Frequency response shall be 20Hz to 20kHz (1W @ 8 Ohms). The Signal-to-Noise Ratio shall be greater than 108dB at rated power into 8 Ohms(unweighted). THD shall be less than 0.05% into 4 Ohms, 20Hz – 20kHz and 10dB below rated power. The amplifier shall have a channel attenuator for each input on the front panel and input sensitivity select switch, a high-pass filter switch and limiter enable switch on the rear panel. The inputs
shall be of balanced bridging type with XLR, ¼” TRS, and 3-pin Euroblock connectors. The outputs shall be four pin Speakon type
connectors. L.E.D type indicators shall be employed to show the relative power level of each channel, clip/protect and power on/off. Self contained forced air cooling (front in) shall be used with front panel mounted, removable dust filters. The power amplifier shall weigh 24lbs/10.9kg net and mount in a standard 19 inch rack using two spaces (3.5inches high). The power requirement shall be 110 – 125VAC, 50 – 60Hz. The power amplifier shall be the Ashly KLR-2000.
 

The KLR Series delivers performance with the best signal/noise ratios of any amp in it's category. Stable down to 2Ω, not only are KLRs covered by Ashly's 5-Year Warranty, they're built to last. Ashly's expertise in construction and switching power supplies means lower weight than amplifiers with conventional input sections. Dollars for Watts, the KLR Series of amplifiers is a tremendous value for those who crave straight-up, high quality power amplifiers

 

KLR Downloads

Model Description Data Sheet Manual A&E Specs Front
Panel
Rear
Panel
Line Art Front Line Art Back
KLR-2000 2-Channel, 1000W @ 2 Ohm / 600W @ 4 Ohm Amplifier, 2U PDF > PDF > DOC > JPG > JPG > DXF > DXF >
KLR-3200 2-Channel, 1600W @ 2 Ohm / 1100W @ 4 Ohm Amplifier, 2U JPG > JPG > DXF > DXF >
KLR-4000 2-Channel, 2000W @ 2 Ohm / 1400W @ 4 Ohm Amplifier, 2U JPG > JPG > DXF > DXF >
KLR-5000 2-Channel, 2500W @ 2 Ohm / 1700W @ 4 Ohm Amplifier, 2U JPG > JPG > DXF > DXF >

datasheet